RocketFish ROCKETBOOST RF-RBREC Guía de usuario descargar pdf (Pagina 23)

23RF-RBKIT

Connecting the additional wireless receiver

Note: This additional wireless receiver (RF-RBREC) is purchased separately.

To connect the additional wireless receiver:

1 Connect the Left Rear speaker to the right speaker-out terminals on the

wireless receiver by connecting the red speaker wire to the red (+)

terminals, and the black speaker wire to the black (-) terminals.

2 Connect the Left Surround speaker to the left speaker-out terminals on

the wireless receiver by connecting the red speaker wire to the red (+)

terminals, and the black speaker wire to the black (-) terminals.

3 Plug one end of the AC power cord into the AC IN jack on the back of the

wireless receiver, then plug the other end of the cord into an AC power

outlet. The Standby indicator turns on.

4 Turn the wireless receiver On by pressing .

5 Pair the wireless receiver with the wireless sender connected to your

amplifier by pressing and holding the button on the wireless sender

for more than three seconds to put it in pairing mode. The power

indicator starts blinking rapidly and the unit will stay in pairing mode for

30 seconds.

-OR-

If the wireless sender connected to your amplifier is not the Rocketboost

hub, then you need to pair the wireless receiver with your existing

Rocketboost hub. See “Pairing the wireless sender and wireless receiver

with an existing Rocketboost network” on page 34.

6 Press and hold the button on the wireless receiver for more than three

seconds so the wireless sender enters pairing mode.

SPEAKER-OUT (4-8 Ohm)

120V~,60Hz

AC IN

Left Surround

Left Rear

RF-RBKIT_10-1329_MAN_V5.fm Page 23 Friday, November 4, 2011 12:06 PM

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 46 47

Sin comentarios

RocketFish ROCKETBOOST RF-RBREC Guía de usuario Pagina 23