
34
• The power indicators blink slowly if the pairing was not successful.
Note: Rocketboost devices have their own memory. After the devices are paired once,
they will remember each other and pair automatically when your devices are
powered on again. Because of this, you can pair all of your network components in
the same room before installing them in their permanent locations throughout the
house.
Pairing the wireless sender and wireless receiver with an
existing Rocketboost network
Use this procedure only if you are adding this product to an existing
Rocketboost network. You need to pair both the wireless sender and
wireless receiver to your existing hub device, using the following
steps.
To pair with an existing Rocketboost network:
1 Set the HUB switch on the wireless sender to DISABLE.
• The power indicators turn green when the HUB switch is set to ENABLE.
• The power indicators turn blue when the HUB switch is set to DISABLE.
2 Press and hold the button on the your Rocketboost Hub device for
more than three seconds to put it into pairing mode. The power
indicator starts blinking rapidly and the unit will stay in pairing mode for
30 seconds.
3 Press and hold the button on the wireless sender for more than three
seconds so the Hub device and wireless sender enter pairing mode.
• The power indicators light steadily if the pairing was successful.
• The power indicators blink slowly if the pairing was not successful.
4 Press and hold the button on your Rocketboost Hub device for more
than three seconds to put it into pairing mode. The power indicator
starts blinking rapidly and the unit will stay in pairing mode for 30
seconds.
5 Press and hold the button on the wireless receiver for more than three
seconds so the Hub device and wireless receiver enter pairing mode.
• The power indicators light steadily if the pairing was successful.
Power on
indicator
RF-RBKIT_10-1329_MAN_V5.fm Page 34 Friday, November 4, 2011 12:06 PM
Comentarios a estos manuales